Filter
Top Products
Introduction
9
NXA-ENET24 - Software Management Guide
System Defaults (Cont.)
Port Configuration Admin Status Enabled
Auto-negotiation Enabled
Flow Control Disabled
Port Capability 100BASE-TX/FX –
• 10 Mbps half duplex
• 10 Mbps full duplex
• 100 Mbps half duplex
• 100 Mbps full duplex
• Full-duplex flow control disabled
1000BASE-T –
• 10 Mbps half duplex
• 10 Mbps full duplex
• 100 Mbps half duplex
• 100 Mbps full duplex
• 1000 Mbps full duplex
• Full-duplex flow control disabled
• Symmetric flow control disabled
1000BASE-X –
• 1000 Mbps full duplex
• Full-duplex flow control disabled
• Symmetric flow control disabled
Power over Ethernet Status Enabled (all ports)
Rate Limiting Input and output limits Disabled
Port Trunking Static Trunks None
LACP Disabled
Broadcast Storm Protection Status Enabled (all ports)
Broadcast Limit Rate 500 packets per second
Spanning Tree Protocol Status Enabled, RSTP
(Defaults: All values based on
IEEE 802.1w)
Fast Forwarding (Edge Port) Disabled
Address Table Aging Time 300 seconds
Virtual LANs Default VLAN 1
PVID 1
Acceptable Frame Type All
Ingress Filtering Disabled
Switchport Mode (Egress Mode) Hybrid: tagged/untagged frames
GVRP (global) Disabled
GVRP (port interface) Disabled
Traffic Prioritization Ingress Port Priority 0
Weighted Round Robin • Class 0: 1
•Class 1: 4
•Class 2: 16
•Class 3: 64
IP Precedence Priority Enabled
IP DSCP Priority Disabled
IP Port Priority Disabled