Filter
Top Products
CLI (Command Line Interface)
191
NXA-ENET24 - Software Management Guide
System Status Commands (Cont.)
Command Function
show running-config
(Cont.)
vlan database
vlan 1 name DefaultVlan media ethernet state active
!
!
interface ethernet 1/1
switchport allowed vlan add 1 untagged
switchport native vlan 1
.
.
.
!
interface vlan 1
ip address DHCP
!
!
no map IP precedence
no map IP DSCP
!
!
line console
!
line vty
!
end
!
Console#
show system
This command
displays system
information.
Default Setting: None
Command Mode: Normal Exec, Privileged Exec
Command Usage: For a description of the items shown by this command, refer to
“Displaying System Information” on page 3-9.
The POST results should all display “PASS.” If any POST test indicates “FAIL,” con-
tact your distributor for assistance.
Example:
Console#show system
System description: 24FE Stackable Intelligent Switch
System OID string: 1.3.6.1.4.1.259.6.10.61
System information
System Up time: 0 days, 0 hours, 0 minutes, and 7.18 seconds
System Name: [NONE]
System Location: [NONE]
System Contact: [NONE]
MAC address: 5A-A5-AA-55-44-32
Web server: enabled
Web server port: 80
Web secure server: enabled
Web secure server port: 443
Telnet server: enable
Telnet port: 23
Jumbo Fram: Disabled
POST result
POST result
UART LOOP BACK Test..........PASS
DRAM Test....................PASS
Timer Test...................PASS
PCI Device 1 Test............PASS
PCI Device 2 Test............PASS
Switch Int Loopback test.....PASS
Done All Pass.
Console#