Filter
Top Products
Port Configuration
90
NXA-ENET24 - Software Management Guide
Statically Configuring a Trunk - CLI
This example creates trunk 2 with ports 1 and 2. Just connect these ports to two static trunk ports on another
switch to form a trunk.
Enabling LACP on Selected Ports
Command Usage
To avoid creating a loop in the network, be sure you enable LACP before connecting the ports, and
also disconnect the ports before disabling LACP.
If the target switch has also enabled LACP on the connected ports, the trunk will be activated
automatically.
A trunk formed with another switch using LACP will automatically be assigned the next available
trunk ID.
If more than four ports attached to the same target switch have LACP enabled, the additional ports
will be placed in standby mode, and will only be enabled if one of the active links fails.
All ports on both ends of an LACP trunk must be configured for full duplex, either by forced mode
or auto-negotiation.
Command Attributes
FIG. 89 CLI - Configuring Port Trunks
Command Attributes
• Member List (Current): Shows configured trunks (Unit, Port).
•New: Includes entry fields for creating new trunks.
• Unit – Stack unit. (Range: 1-8)
• Port – Port identifier. (Range: 1-26)