Filter
Top Products
Class of Service Configuration
146
NXA-ENET24 - Software Management Guide
Copy Settings - Web
Click Priority, Copy Settings. Select the source priority settings to be copied, enter the source port or trunk
number and choose the destination interface/s to copy to, then select Copy Settings.
Copy Settings - CLI
CLI – The following example shows how to map HTTP traffic to CoS value 0 on port 5, maps IP precedence
to CoS 0 to port 6, and enables mapping IP DSCP globally.
Mapping CoS Values to ACLs
Use the ACL CoS Mapping page to set the output queue for packets matching an ACL rule as shown in the
following table. Note that the specified CoS value is only used to map the matching packet to an output queue;
it is not written to the packet itself. For information on mapping the CoS values to output queues, see page 138.
Command Usage - You must configure an ACL mask before you can map CoS values to the rule.
FIG. 171 Web - Copy Settings
Console#con
Console(config)#interface ethernet 1/5
Console(config-if)#map ip port 80 cos 0 360
Console(config)#interface ethernet 1/6
Console(config-if)#map ip precedence 1 cos 0 361
Console(config-if)#exit
Console(config)#map ip dscp 362
Console(config)#
CoS to ACL Mapping
Queue 0123
Priority 1,2 0,3 4,5 6,7
Command Attributes
•Port: Selects the port to which the ACL CoS is configured on.
• Name: Name of ACL. For information on configuring ACLs, see the Configuring
ACLs section on page 73.
•Type: Type of ACL (IP or MAC).
• CoS Priority: Enables the CoS priority value level.
•Add: Adds the specified information to the port.
• ACL CoS Priority Mapping: Displays the configured information.