Filter
Top Products
Configuring Event Logging
40
NXA-ENET24 - Software Management Guide
System Log Configuration - Web
Click System, Log, System Logs. Specify System Log Status, then change the level of messages to be logged to
RAM and flash memory, then click Apply.
System Log Configuration - CLI
Enable system logging and then specify the level of messages to be logged to RAM and flash memory. Use the
show logging command to display the current settings. Type “show log ram” to display log messages in the
RAM buffer.
Remote Logs Configuration
The Remote Logs page allows you to configure the logging of messages that are sent to syslog servers. You can
also limit the error messages sent to only those messages below a specified level.
Command Attributes
FIG. 26 Web - System Logs
FIG. 27 CLI - System Logs
Command Attributes
• Remote Log Status: Enables/disables the logging of debug or error messages to the remote logging
process.
• Default: Enabled
• Logging Facility: Sets the facility type for remote logging of syslog messages. There are eight facility
types specified by values of 16 to 23.
The facility type is used by the syslog server to dispatch log messages to an
appropriate service.
• Default: 23
• Logging Trap: Limits log messages that are sent to the remote syslog server for all levels up to the
specified level. For example, if level 3 is specified, all messages from level 0 to level 3
will be sent to the remote server.
• Default: 3
• Host IP List: Displays the list of remote server IP addresses that receive the syslog messages.
The maximum number of host IP addresses allowed is five.
• Host IP Address: Specifies a new server IP address to add to the Host IP List.