Filter
Top Products
Modem and power management connection protocols
The following table shows the connection protocols for modems or IPDUs connected to the
serialports.
Protocol Name Result
PPP-NoAuth
StartsaPPPsession withoutinteractiveauthentication required.
Assumesthespecifiedconsoleserver serialportisconnectedto an
externalmodem.
PPP
StartsaPPPsession withauthenticationrequired.Assumesthe
specifiedconsoleserver serialportisconnectedto an external
modem.
SLIP
StartsaSLIPsession.Assumesthespecified consoleserver serial
portisconnectedto an externalmodem.
CSLIP
StartsaCSLIPsession.Assumesthe specifiedconsoleserver serial
portisconnectedto an externalmodem.
Power Management
Configurestheserialportfor power management.Assumesan
IPDU isconnectedto the serialport.
Table 9.3: Connection Protocols for Modems or IPDUs.
To configure a serial port connection protocol for a console connection:
This procedure assumes that the selected serial port is physically connected to a console port on
adevice.
1. Go to Ports - Physical Ports in Expert mode, select a port or ports to modify and click the
appropriate Modify Ports button. The General form appears.
2. Click the General tab. The General form appears with the number(s) of the selected port(s)
next to the Done button at the bottom of the form. All active tabs are yellow.
3. To change the connection protocol, select one of the options from the Connection Protocol
pull-down menu: Console (Telnet), Console (SSH), Console (Telnet & SSH) or Console
(Raw). The default is Console (Telnet).
4. If you wish to change any of the other current settings, see To configure serial port settings
to match the connected devices: on page 111.
5. To further configure the serial port’s connection protocol:
• For user access and authentication methods see Access on page 112.
• For TCP Port number and other port configuration options see Other on page 121.
Chapter 9: Ports Menu and Forms 107