Filter
Top Products
CAUTION
Installation
Setting up and moving of the printer should only be carried
out by a qualified technician.
The printer machine weighs approximately 230 kg (507
lb). Transporting and setting up of the printer should be
held in proper way.
The machine may fall down and cause injury.
The printer must be used on a suitable stable surface,
otherwise it may tip over or fall down and cause injury.
Furthermore, the table that supports the printer should be
at least 180 cm (70.9 inch) in width and 90 cm (35.4 inch)
in depth, and should be able to bear a weight of 250 kg
(555 lb) or more.
Do not set up the printer in a place where it will be affected
by vibration. It may become unbalanced and fall down,
which cause injury or damage to the printer.
Do not connect the power cord until setup is complete,
otherwise the printer may operate if the power switch is
turned on by mistake, which could result in injury.
Do not climb onto the printer or place heavy objects on top
of it, otherwise it may become unbalanced and tip over or
fall down and cause injury.
Printing
This printer should only be used by operators who are
appropriately trained in its operation.
Ensure there is adequate space left for safe working. The
Platen moves forward while operating and it may be
injured.
Do not handle the platen while printing. If your hand gets
caught between the platen or the T-shirt tray and the
covers, it may be injured.
Do not move the Platen by hand.
The Printer may be mechanically and electrically
damaged.
Do not put your hands inside the covers while the printer’s
power is turned on, otherwise your hands may touch
against moving parts and this may result in injury.
When a problem occurs with the operation of the printer,
contact the place of purchase or a qualified technician.
Maintenance
Wait at least 1 minute after turning off the power switch
before opening the front cover.
Do not touch the head heat sink as it may be HOT and
may cause a burn.
Be careful not to get your fingers caught when closing the
front cover, otherwise it may result in injury to your fingers.
Do not move the Platen by hand.
The Printer may be mechanically and electrically
damaged.
Do not disassemble the ink cartridge.
Take care not to let the ink, Wash Liquid, Maintenance
Solution, Pretreatment or waste liquid
come into contact
with your eyes or onto your skin, otherwise inflammation
can result. In case of contact with eyes, do not rub but
immediately rinse the eyes with water.
Furthermore, do not drink the ink, Wash Liquid,
Maintenance Solution, Pretreatment or waste liquid under
any circumstances, as they can cause vomiting and
diarrhea.
Keep the ink, waste liquid and wash liquid out of the reach
of children.
Use only the proper replacement parts as specified by
Brother.
GT-782
iii