Filter
Top Products
GT-782
4. Printing Directly from Applications
59
(3) Roll a roller on the surface so that the Pretreatment can sink equally.
(4) Put the T-shirt on the heat press. Keep the surface flat without wrinkles. Use a separator sheet and press with high
pressure. Curing condition is the same as ink: 180°C (356°F) in 35 seconds.
(5) Remove the T-shirt from the heat press and cool.
4-6-2. Making One Print
GT-782 receives the next print data from PC in printing. The print data is replaced after the print is finished.(This means when
a print data has both Color and White data, the white print data starts being replaced after the White Print Heads finish
printing.) If you press the Print Button under this situation then it seems that different print data seems to be printed at the
same time. When you press the Print Button, confirm the Job Comment (or file name) and the counter on the display of the
Control Panel.
(1) Make sure the Print Button has been turned on, which indicates your printer has received the print data successfully.
(2) Make sure that the Platen is ejected. If not, press the Platen Button.
(3) Confirm the Job Comment on the Display shows the correct print job details. Check the counter whether it is 000 (new) or
not (previous).
(4) Press the Print Button to start printing operation
When the printing is completed, the Platen is ejected and an audible indication is given.
If printing is to be stopped before it is finished the Stop button can be used.
<Note>
By pressing the Print Button, your printer automatically starts cleaning the Print Head every 24 prints (default) or every
numbers of prints you have set (see "7-2-5. Changing the Auto Head Cleaning Setting”), or after your printer has not
been used for
more than two hours. In this case, wait until the cleaning completes (takes about 20 seconds), and
then printing will automatically start.
Keep away from the moving platen.
If the Platen is not at the appropriate position when the Print Button is pressed, it automatically adjusts the position to
start printing. Press the Print Button again to start printing after the Platen is available
Do not open unlock or open the Cover during printing. If you do the power is turned off for safety reasons.
4-6-3. Printing More than One Print Using the Same Print Data
After making one print following the procedure in “4-6-2. Making One Print”, you can continue making more prints using the
same print data.
(1) Confirm the Platen height and the Print Direction.
(2) Press the Print Button of the other side of the Platen to start printing. The counter indicates how many images are printed
by both Platens.
<Note>
The counter indicates the total prints of one print data with both Platens.
You can press the Print Button in advance while the other Platen is printing. In this case the print starts after the Print
Heads finish printing the data.