Filter
Top Products
GT-78２
6. Maintenance
73
(14) Use the other side of the wet Clean Applicator to clean the rear of the Wiper Blade.
(15) Wet other two Clean Applicators and use them to remove ink or dust from the Print Head Caps.
Use one side of the Clean Applicator to clean one Print Head Cap.
<Note>
Do not use dry Clean Applicator; it cannot clean ink or dust. It may damage the Print Head Caps. Wipe off the dirty ink of
Clean Applicator with soft cloth if it is too dirty and wet with Wash Liquid.
(16) Insert the Wiper Cleaner Cassette straight into your printer.
<Note>
Do not touch the Clearance Sensor (the bar above the Wiper Cleaner Cassette).
(17) Check the top edge of the black Flash Plate on the right and the front/back surface of the Obstruction Sensor, if they are
dirty with ink and/or dust wipe off the dirt with a soft wet cloth with water.
<Note>
When ink or dust is mounted high on the top edge of the Flash Plate, it may touch the surface of the print head during
printing, this may cause misfiring. When the surface/back of the Obstruction Sensor is dirty, it may damage the printing
material when loading.
(18) Close the Front Cover, and then turn on your printer.
If your printer turns on with no errors, replacement of the Wiper Cleaner has been completed.
If there is problem (abnormal noise or error "No Wiper Cleaner "), turn off your printer, and check if the Wiper Cleaner and
the Wiper Cleaner Cassette are correctly installed.