Filter
Top Products
4. Printing Directly from Applications
4-4-3. Lowering the Platen height
By replacing to the GT-541's parts the Platen height can be lower by 10 mm (12 - 22 mm from the surface of the Print Heads).
Prepare a screw driver and hexagon wrench.
(1) Loosen the Platen Fixing Lever and uninstall the Platen by lifting it up straight.
(2) Remove the three screws that fix the Platen Height Adjustment Lever, and remove the two nuts that fix the Platen
Positioning Plate.
Platen Positioning Plate
Platen Height Adjustment Lever
(3) Replace the Bush Platen Shaft which is under the Height Adjusting Lever and Platen Positioning Plate to the GT-541's
parts.
(4) Install the Platen as it is and fix it. Insert the Platen Fixing Lever into the lower hole and tighten it. The upper hole is for
GT-782.
for GT-782 (normal)
when lowering the Platen
height by 10 mm
GT-782
54