Filter
Top Products
1.
Print a Nozzle Check Pattern. (☞56)
2.
If the quality of the pattern is poor, clean the print head four or five
times. (☞85)
3.
Print another Nozzle Check Pattern. If the pattern is still poor, flush
the print head twice. (☞85)
4.
If print head flushing fails to correct the problem, follow the
procedure below to replace the BJ Cartridge.
Replacing a BJ Cartridge
Follow this procedure to replace the BJ Cartridge.
The Black BJ Cartridge BC-10, Color BJ Cartridge BC-11e and BJ
Cartridge BC-12e Photo were designed specially for this printer. Never
attempt to use any other type of cartridge with this printer.
1.
Check the printer POWER lamp and make sure that it is switched
on. If the printer is off, press the POWER button to switch it on.
2.
Press the CARTRIDGE button. The cartridge holder moves to the
centre and the POWER lamp flashes.
• You can use the printer driver screen to replace or switch the BJ
Cartridge. For details, see the
Windows Printer Driver Guide
or the
Macintosh Printer Drive Guide
.
If the low-ink warning is switched on, the replacement procedure is
different. (
☞68)
• If the print head is overheated, it may not move to the centre
immediately. Wait a few minutes for the print head to cool down. Never
attempt to move the cartridge manually by pushing it or pulling on the
film cable.
3.
Remove the BJ Cartridge and install a new BJ Cartridge. Follow the
same procedure used to replace a Color BJ Cartridge BC-11e with a
Black BJ Cartridge BC-10. (☞51)
Dispose of the old BJ Cartridge immediately.
You may want to place it in a plastic bag to prevent spillage from the
print head.
73
Chapter 5 Daily Operation and Printer Maintenance
5