Filter
Top Products
102
Customizing System Operation (System Settings)
Assigning a Channel
for Remote Control
> [System settings] > [Remote
control channel]
When using multiple projectors at
the same time (maximum 4), you can
assign a different channel to each
remote control so that each operates
independently.
Selecting the Projector Channel
Press the OK button to accept your
setting and then press the MENU
button.
• The factory default is [Independent] for both
projector and remote control.
• After changing the channel on the menu, be
sure to change the channel of the remote
control too.
• If an optional wired remote control (RS-
RC05) is used, there is no need to set the
remote control channel.
Selecting a Channel on the
Remote control
You can change the channel on the
remote control as follows.
HDMI Component LAN
Digital PC Analog PC USB
Ch1
Ch2
Ch3
Ch4
Select the remote control
channel to use with this
projector.
Independent Remote controls set to any
channel can be used.
Ch1 Press and hold the OK
button and [ ] button at the
same time for 3 seconds.
Ch2 Press and hold the OK
button and [ ] button at the
same time for 3 seconds.
Ch3 Press and hold the OK
button and [ ] button at the
same time for 3 seconds.
Ch4 Press and hold the OK
button and [ ] button at the
same time for 3 seconds.
Independent Press and hold the OK
button and button at the
same time for 3 seconds.
Downloaded From projector-manual.com Canon Manuals