Filter
Top Products
Menu Configuration
230
Factory default settings are set according to the following conditions.
*1
• [Off] by default when HDMI ([HDMI In]) is [Computer], or for Digital PC, Analog PC (1 or 2), USB, or LAN.
• HDMI (when [HDMI In] is [Auto]) or Component: Weak
*2
• For HDMI (when [HDMI In] is [Computer]), Digital PC, Analog PC (1 or 2), USB, or LAN, the factory default
is [Off] in image modes other than [VividPhoto]. Default in [VividPhoto] mode: [Middle].
•
For HDMI (when [HDMI In] is [Auto]) or Component, the factory default is [Weak], regardless of the image mode.
Advanced adjustment
Ambient light (when Photo/sRGB is selected) Off* P89
Adjust
Type Tungsten
Fluorescent
Level
L
H
Random noise reduction
Digital PC / Analog PC-1/2 / HDMI / Component
P90
Off*
Weak
Middle
Strong
MPEG noise reduction
Digital PC / Analog PC-1/2 / HDMI / Component
P90
Off*
Weak
Middle
Strong
Mosquito noise reduction USB / LAN P91
Off*
Weak
Middle
Strong
Dynamic gamma*1 Off P91
Weak
Middle
Strong
Mem. color correct*2 Flesh Off P92
Sky Weak
Green Middle
Strong
6-axis color adjust Off* P92
Adjust
Hue / Saturation /
Brightness
Reset
Fine-Tune Gamma P93
Lamp control Off* P94
On
Lamp mode Full power* P95
Power saver
Reset OK / Cancel P95
*: Factory defaults (setting after reset)
Downloaded From projector-manual.com Canon Manuals