Filter
Top Products
Completing Projector Settings
167
Installation and Maintenance Connecting to a Network
Registering a Network
Password
> [Network settings] > [Register
network password]
Register the projector network
password.
When [Register network password] is
selected, the window shown below
appears.
Enter a 4-digit password.
Enter the password using the [ ] / [ ] /
[ ] / [ ] buttons on the remote control.
Press the OK button to accept your
setting and then press the MENU
button.
• If you forget the password, press [ ] [OK]
[ ] [OK] [ ] [OK] to restore the factory
default setting.
• The factory default is [ ] [ ] [ ] [ ].
Specifying Standby
Power Consumption
> [Network settings] > [Network
standby settings]
Specify network function operating
status in standby mode as follows.
Press the OK button to accept your
setting and then press the MENU
button.
• [Low-power] is the factory default.
• [Low-power] may delay access over the
network for some functions. For faster
access, select [Normal].
• Power consumption when [Network function
(wired)] is [On] varies depending on
whether [Network standby settings] is set to
[Normal] or [Low-power].
Normal All network functions are available
even in standby mode, including
the web screen, control over the
network, and PJLink.
Low-
power
All network functions are available
even in standby mode.
However, the projector may be
less responsive than usual when
some functions are initially used.
Downloaded From projector-manual.com Canon Manuals