Filter
Top Products
114
Before Installation
Precautions When Carrying/Shipping the
Projector
Precautions for Installation
Be sure to read “Safety Instructions” and “For Safe Use” (P10 – P23). Also
take the following precautions during installation.
Prepare the projector as described below before carrying it.
• Disconnect the cables connected to the projector. Carrying the
projector with the cables attached may cause an accident.
• Retract the adjustable feet.
• When carrying or holding up the projector after attaching the
lens unit, be sure not to hold the lens. Doing so may cause
damage to the projector.
• Do not reuse any packaging or shock-absorbent materials that
were supplied with the projector at the time of purchase for
transporting or shipping the projector.
Protection of the projector cannot be guaranteed if used
packaging or shock-absorbent materials are reused. Fragments
from shock-absorbent material may also enter the interior of the
projector which could cause a malfunction.
• If transportation is necessary, the lens unit should be removed
before transporting the projector. If the projector is subjected to
excessive impacts during transportation, the lens unit may be
damaged.
Removal and installation of the lens unit should not be
performed by the user. Be sure to have the procedure performed
by a qualified technician or contact the Canon Customer
Support Center.
• Do not strike the projector or
subject it to impact. Doing so may
cause a malfunction.
• Do not install the projector so that it
is inclined or standing vertically. The
projector may tip over, causing a
malfunction.
• Do not block the air intake or
exhaust vents of the cooling fan. If
the intake or exhaust vent is
blocked, heat may accumulate
inside the projector, causing a malfunction.
Exhaust vent
Air intake vent
Downloaded From projector-manual.com Canon Manuals