Filter
Top Products
Installation Procedure
123
Installation and Maintenance Installation
8 Insert the projector lens cable into the connector until a click sound is
heard.
9 Reinstall the sleeve, cosmetic panel, and lamp cover in their original
positions.
When the power is first turned on after the lens unit has been installed or replaced, lens
shift initialization operation will be performed. It will take approximately 1 minute for the
initialization operation to start up. However, if the lens has been replaced with a lens of
the same model number, initialization operation will not be performed. The position will be
the same as before the lens was replaced.
The lens shift initialization operation uses the motor to move the lens
up / down / left / right. Do not touch the lens. Doing so could result in
an injury.
When installing and removing the lens unit, be sure to fix the lens
cable as shown in the illustration. When inserting the lens unit, it is
possible to damage the lens cable between the lens unit and projector.
Downloaded From projector-manual.com Canon Manuals