Filter
Top Products
30-18
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 30 Configuring EIGRP
Feature History for EIGRP
• ROUTE FILTER CHANGED—The EIGRP neighbor is resetting because there is a change in the
route filter.
• INTERFACE DELAY CHANGED—The EIGRP neighbor is resetting because there is a manual
configuration change in the delay parameter on the interface.
• INTERFACE BANDWIDTH CHANGED—The EIGRP neighbor is resetting because there is a
manual configuration change in the interface bandwidth on the interface.
• STUCK IN ACTIVE—The EIGRP neighbor is resetting because EIGRP is stuck in active state. The
neighbor getting reset is the result of the stuck-in-active state.
Step 2 Click the EIGRP neighbor that you want to monitor.
Step 3 To remove the current list of neighbors, click Clear Neighbors.
Step 4 To refresh the current list of neighbors, click Refresh.
Note By default, neighbor change and neighbor warning messages are logged.
Feature History for EIGRP
Table 30-1 lists each feature change and the platform release in which it was implemented. ASDM is
backward-compatible with multiple platform releases, so the specific ASDM release in which support
was added is not listed.
Table 30-1 Feature History for EIGRP
Feature Name
Platform
Releases Feature Information
EIGRP support 7.0(1) Support was added for routing data, performing
authentication, and redistributing and monitoring routing
information using the Enhanced Interior Gateway Routing
Protocol (EIGRP).
We introduced the following screen: Configuration >
Device Setup > Routing > EIGRP.