Filter
Top Products
7-8
Cisco ASR 1001-X Router Hardware Installation Guide
OL-32376-02
Chapter 7 Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Removing and Replacing Cisco ASR 1001-X Router USB Flash Memory Stick or Secure Token
Figure 7-7 DC Power Supply with Lead Wires
Step 7
Repeat these steps for the remaining DC input power source wire as applicable.
Step 8 Use a tie wrap to secure the wires to the rack, so that the wires are not pulled from the terminal block by
casual contact.
Step 9 Turn on the circuit breaker at the power source.
Step 10 If you have changed the Standby switch to the standby position in step 1, turn the Standby switch to the
On position.
The power supply LEDs illuminate green.
This completes the procedure for connecting the DC power supply in the Cisco ASR 1001-X Router.
Removing and Replacing Cisco ASR 1001-X Router USB Flash
Memory Stick or Secure Token
The Cisco ASR 1001-X Router contains ports for a flash memory stick or a secure token, to store
configurations or Cisco IOS XE consolidated packages.
Figure 7-8 shows USB port 0 or 1 connector on the Cisco ASR 1001-X Router for the flash memory stick
or secure token.
1 Negative (–) lead wire 2 Positive (+) lead wire
372766
1
2