Filter
Top Products
5-4
Cisco ASR 1001-X Router Hardware Installation Guide
OL-32376-02
Chapter 5 Cisco ASR 1001-X Router Power Up and Initial Configuration
Performing the Initial Configuration on the Router
Press RETURN to get started!
*May 13 15:17:59.791: %SMART_LIC-6-AGENT_READY: Smart Agent for Licensing is initialized
*May 13 15:18:00.810: %IOS_LICENSE_IMAGE_APPLICATION-6-LICENSE_LEVEL: Module name =
asr1001x Next reboot level = adventerprise and License = adventerprise
*May 13 15:18:03.504: %IOSXE_THROUGHPUT-6-LEVEL: Throughput level has been set to 20000000
kbps
*May 13 15:18:14.767: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan
*May 13 15:18:17.981: VOIPHA: removing default handlers
*May 13 15:18:18.838: %LINK-3-UPDOWN: Interface Lsmpi0, changed state to up
*May 13 15:18:18.838: %LINK-3-UPDOWN: Interface EOBC0, changed state to up
*May 13 15:18:18.839: %LINEPROTO-5-UPDOWN: Line protocol on Interface VoIP-Null0, changed
state to up
*May 13 15:18:18.839: %LINEPROTO-5-UPDOWN: Line protocol on Interface LI-Null0, changed
state to up
*May 13 15:18:18.839: %LINK-3-UPDOWN: Interface GigabitEthernet0, changed state to down
.
.
.
Performing the Initial Configuration on the Router
You can perform initial configuration on the router using the procedure described in the following
sections:
• “Using the Cisco setup Command Facility” section on page 5-4
• “Using the Cisco IOS-XE CLI—Manual Configuration” section on page 5-7
Using the Cisco setup Command Facility
The setup command facility prompts you to enter the information that is needed to configure a router
quickly. The facility takes you through an initial configuration, including LAN and WAN interfaces.
Note The setup command facility is entered automatically if there is no configuration on the router when it is
booted into Cisco IOS-XE.
For information on modifying the configuration after you create it, see the Cisco IOS XE Configuration
Guide and the Cisco IOS XE Command References.
This section explains how to configure a host name for the router, set passwords, and configure an
interface to communicate with the management network.
Note If you make a mistake while using the setup command facility, you can exit and run the setup command
facility again. Press Ctrl-C, and enter the setup command in privileged EXEC mode (Router#).
Step 1 From the Cisco IOS-XE CLI, enter the setup command in privileged EXEC mode:
Router> enable
Password: <password>
Router# setup