Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 6.0)
210
Selecting the Lamination Position
Step Procedure
1 The Lamination Position control allows you to adjust the horizontal position of
the PolyGuard overlaminate. This control functions in the exact same fashion
as the Image Position controls, except only the horizontal position of the
overlaminate requires adjustment.
To adjust the lamination position, click on the Horizontal adjustment
arrows.
To move the overlaminate more toward the Card output side of the Printer,
enter a positive number.
To move the overlaminate more toward the card input side of the Printer,
enter a negative number. (Note: The adjustment arrows point in the
direction the patch will move on the card. The maximum value for the
Horizontal adjustment is ±100 pixels (10 pixels = about .03"/.8mm).)
To adjust the Vertical placement of the PolyGuard overlaminate, see the
Loading the Overlaminate procedure in Section 3, page 115.
Continued on the next page