Filter
Top Products
Time Protocols
SNTP: Viewing, Selecting, and Configuring
CLI: Viewing and Configuring SNTP
CLI Commands Described in this Section
SNTP Command Page
show sntp 9-8
[no] timesync 9-10 and ff.,
9-14
sntp broadcast 9-11
sntp unicast 9-12
sntp server 9-12 and ff.
Protocol Version 9-10
9-12
Priority 9-10
9-12
poll-interval 9-14
no sntp 9-15
This section describes how to use the CLI to view, enable, and configure SNTP
parameters.
Viewing the Current SNTP Configuration
Syntax: show sntp
This command lists both the time synchronization method
(TimeP, SNTP, or None) and the SNTP configuration, even if
SNTP is not the selected time protocol.
For example, if you configured the switch with SNTP as the time
synchronization method, then enabled SNTP in broadcast mode with the
default poll interval, show sntp lists the following:
9-8