Filter
Top Products
File Transfers
Copying Diagnostic Data to a Remote Host, PC or UNIX Workstation
Syntax: copy crash-data [<slot-id> | master] tftp <ip-address> <filename>
copy crash-data [<slot-id>| mm] xmodem
where: slot-id = a - h, and retrieves the crash log or crash data from
the processor on the module in the specified slot.
mm Retrieves crash log or crash data from the switch’s
chassis processor. When “mm” is specified, crash
files from both management modules are copied.
These commands copy the crash data content to a remote host
or to a serially connected PC or UNIX workstation. You can
copy individual slot information or the management module
(mm) switch information. If you do not specify either, the
command defaults to the mm data.
For example, to copy the switch’s crash data to a file in a PC:
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-13.Example of Copying Switch Crash Data Content to a PC
Copying Crash Log Data Content to a Destination Device
Syntax: copy crash-log tftp <ip-address>
copy crash-log xmodem
These commands copy the Crash Log content to a remote host
or to a serially connected PC or UNIX workstation.
A-30