Filter
Top Products
File Transfers
Transferring Switch Configurations
TFTP: Copying a Customized Command File to a Switch
Using the copy tftp command with the show-tech option provides the ability to
copy a customized command file to the switch. When the show tech custom
command is executed, the commands in the custom file are executed instead
of the hard-coded list of commands. If no custom file is found, the current
hard-coded list is executed. This list contains commands to display data such
as the image stamp, running configuration, boot history, port settings, and so
on.
Syntax: copy tftp show-tech <ipv4 or ipv6 address> <filename>
Copy a customized command file to the switch.
ProCurve(config)# copy tftp show-tech 10.10.10.3 commandfile1
Figure A-9. Example of Using the copy tftp show-tech Command to Upload a
Customized Command File
Syntax: show tech custom
Executes the commands found in a custom file instead of the
hard-coded list.
Note: Exit the global config mode (if needed) before executing
show tech commands.
You can include show tech commands in the custom file, with the exception
of show tech custom. For example, you can include the command show tech all.
If no custom file is found, a message displays stating “No SHOW-TECH file
found.”
ProCurve# show tech custom
No custom file was uploaded with the copy tftp show-
No SHOW-TECH file found.
tech command
Figure A-10. Example of the show tech custom Command
A-25