Filter
Top Products
Switch Manager
72 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Network properties
Use the Network Properties dialog box to change the following network settings:
■ IP Configuration parameters
■ SNMP Configuration parameters
■ SNMP Trap Configuration
■ Remote Logging parameter
1. Select a switch in the topology display or open the faceplate display.
2. Select Switch > Network Properties. The Network Properties dialog box is displayed
(Figure 27).
3. After making changes, click OK to put the new values into effect.
Note: Read Community, Trap Community, and Write Community are similar to passwords and are
write-only boxes. Current settings are not displayed.
Figure 27: Network Properties dialog box
IP Configuration parameters
The IP configuration identifies the switch on the Ethernet network and determines which
network discovery method to use. Table 15 describes the IP configuration parameters.