HP (Hewlett-Packard) A9834-9001B Server User Manual


 
Chapter 3
Installing the System
Setting Up the System
105
Figure 3-27 A 5-Wire Connector
Use the following procedure to install the PDCA:
WARNING Make sure the circuit breaker on the PDCA is OFF.
Step 1. Remove the rear PDCA bezel by removing the four retaining screws.
Step 2. Run the power cord down through the appropriate opening in the floor tile.
Step 3. Insert the PDCA into its slot and secure with four screws (Figure 3-28 on page 106).
L1 PE
L3 N
L2