Filter
Top Products
Chapter 3
Installing the System
Setting Up the System
110
Removing the EMI Panels
Remove the front and back electromagnetic interference (EMI) panels to access ports and to visually check
whether components are in place and the LEDs are properly illuminated when power is applied to the system.
To remove the front and back EMI panels:
Step 1. Using a T-20 driver, loosen the captive screw at the top center of the front EMI panel (Figure 3-32).
Figure 3-32 Removing Front EMI Panel Screw
Step 2. Use the handle provided to remove the EMI panel and set it aside.
When in position, the EMI panels (front and back) are tightly in place. Removing them takes
controlled but firm exertion.
Step 3. Loosen the captive screw at the lower center of the back EMI panel (Figure 3-33 on page 111).
Front EMI panel screw