Filter
Top Products
Appendix B
Management Processor Commands
MP Command: RE
200
MP Command: RE
RE - Reset Entity
• Access level—Operator
• Scope—Complex
This command resets the specified entity. Care should be exercised when resetting entities because of the side
effects. Resetting an entity has the following side effects.
– Main backplane - The CLU asserts the backplane_reset signal on the backplane which results in the
following being reset:
* All XBCs, RCs, cells plugged into backplane, Dillons, CCs, all CPUs except PDHC, any attached RIOs, all
I/O adapters installed in the I/O backplanes associated with the above RIOs.
– Cell - The SINC asserts the mpon signal to Dillon which results in the following being reset:
* Dillon, CC, all CPUs except SINC, any attached RIO, all I/O adapters installed in the I/O backplane
associated with the above RIO
– I/O backplane - The CLU asserts the iobackplane_reset signal to the appropriate I/O backplane which
results in the following being reset:
* RIO and all I/O adapters installed in the I/O backplane
• Example:
MP:CM> re
This command resets a hardware device.
C - Cell
I - IO Chassis
M - Main Backplane
Select device: m
Enter cabinet number: 0
Do you want to reset the Main Backplane in Cabinet 0? (Y/[N]) y
-> The selected device(s) will be reset.
MP:CM>
• See also: PE