Filter
Top Products
Chapter 3
Installing the System
Connecting the MP to the Customer LAN
121
Setting the Customer IP Address
NOTE The default IP address for the customer LAN port on the MP is 192.168.1.1.
To set the customer LAN IP address:
Step 1. From the MP Command Menu prompt (MP:CM>), enter lc (for LAN configuration).
The screen displays the default values and asks if you want to modify them. It is a good idea to
write down the information, as it may be required for future troubleshooting.
If you are not already in the Command Menu, enter ma to return to the Main Menu, then enter cm.
When you enter lc, the screen shown in Figure 3-39 appears.
Figure 3-39 LAN Configuration Screen
If the LAN software on the MP is working properly, you should see the message “LAN status: UP
and RUNNING”. The value in the IP address field has been set at the factory. Obtain the customer
LAN IP addresses from the customer.
NOTE The customer LAN IP address is designated LAN port 0.
Step 2. The prompt asks if you want to modify the LAN port 0. Enter Y.
The current customer IP address is shown; then the following prompt appears: Do you want to
modify it? (Y/[N])
Step 3. Enter Y.
Step 4. Enter the new IP address.
The customer provides this address for LAN port 0.
Step 5. Confirm the new address.
Step 6. Enter the MP network name.