Filter
Top Products
Chapter 2
System Specifications
Electrical Specifications
64
NOTE A qualified electrician must wire the PDCA receptacle to site power using copper wire and in
compliance with all local codes.
All branch circuits used within a complex must be connected together to form a common ground. All power
sources such as transformers, UPSs, and other sources, must be connected together to form a common ground.
When only one PDCA is installed in a system cabinet, it must be installed as PDCA 0. Refer to Figure 2-1 for
the location of PDCA 0.
NOTE When wiring a PDCA, phase rotation is unimportant. When using two PDCAs, however, the
rotation must be consistent for both.
7 3-phase Voltage range 200
to 240 V ac,
phase-to-neutral,
50 Hz / 60 Hz
5-wire 24 A maximum
per phase
Connector and plug
provided with a 2.5 meter
(8.2 feet) power cable.
Electrician must hard wire
receptacle to 32 A site
power.
a. A dedicated branch circuit is required for each PDCA installed.
Table 2-7 Option 6 and 7 Specifics
PDCA
Part Number
Attached Power Cord Attached Plug
Receptacle
Required
A5201-69023
(Option 6)
OLFLEX 190 (PN 600804) is a 2.5 meter (8.2 feet)
multi conductor, 600 V, 90° C, UL and CSA
approved, oil resistant flexible cable (8 AWG 60 A
capacity).
Mennekes
ME 460P9
(60 A capacity)
Mennekes
ME 460R9
(60 A capacity)
A5201-69024
(Option 7)
H07RN-F (OLFLEX PN 1600130) is a 2.5 meter
(8.2 feet) heavy-duty neoprene-jacketed
harmonized European flexible cable (4 mm
2
32 A
capacity).
Mennekes
ME 532P6-14
(32 A capacity)
Mennekes
ME 532R6-1500
(32 A capacity)
Table 2-6 Available Power Options (Continued)
Option
Source
Type
Source Voltage
(Nominal)
PDCA
Required
Input Current
Per Phase 200
to 240 V ac
a
Power Receptacle
Required