Filter
Top Products
7-24
Contents and display
Extension
function
code
➤
➤
➤
➤
1
➤
1
FUNC
FUNC
.
.
➤
Running
mode
selection
➤
➤
1
2
➤
FUNC
FUNC
➤
Set value
Function
0
Normal running mode
1 Energy conservation running mode
Initial value
Setting method
Select the running mode. Set the running mode to be used.
2
Fuzzy most suitable acceleration
and deceleration mode
Initial value
NOTE: When the fuzzy most suitable acceleration and deceleration are selected and the load inertia (motor shaft
conversion) is more than about 20 times of that of the individual motor, an overvoltage trip may occur.
If this occurs, reset the mode to the normal running mode. For other precautions, refer to "Precautions for
fuzzy most suitable acceleration and deceleration" of Appendix 1.
Jogging
frequency
setting
.
2
2
➤
➤
➤
Set the running command so as to be inputted to the terminal.
(Set to or .)
Since jogging is a direct input operation and may be easily tripped, set the jogging frequency
to 5 Hz or less.
Setting method
Initial value
NOTE:
No frequency can be set
between 0.01 Hz and 0.09 Hz.
CM1 FW 8 3
SWFW
(REV)
SWJG
(JG)
Operation timing
SWJG
SWFW
Motor
rotation
Free run
20 msec min
The free run operation is performed immediately after
SWFW is turned OFF.
No jogging operation is performed when the set value is smaller than the start frequency .
➤
➤
➤
1
2
FUNC
FUNC
➤
Reduced
voltage
soft start
setting
Adjust reduced voltage start.
Initial value
NOTE: How to set
There is no reduced voltage. The rush
current at the start of the inverter is
increased but the motor reaction time is
decreased.
The effect of the reduced voltage is
large.
The rush current is reduced but the
motor reaction time is increased.
:
:
¥
¥
¥
¥