Filter
Top Products
7-30
Contents and display
Extension
function
code
Output
terminal
setting
11 and 12
A terminal function is allocated to each of the output intelligent terminals 11 and 12. When using
a function other than the standard set functions or changing the terminal order, set the function for
each terminal.
1
2
➤
FUNC
➤
Code Function name
Terminal
rating plate
Initial
setting
Output terminal setting 11C10
C11
Output terminal setting 12
11 0
12 1
Arrary of codes and intelligent terminals
PCB terminal array
The setting method is the same
as that of the input terminals
to .
Setting method
Press the key once for the terminal code to be set.
The set values of the terminals which are set at present are displayed. Display the set value
of the terminal to be used from the function list indicated below by pressing the key
and and then press the key.
The display is returned to the code display and the terminal function is changed.
FUNC
1
2
FUNC
➤
FUNC
Enter the set value of the terminal name
to be used by pressing the keys and .
Set value
Function name
0
1
2
Input terminal function list
FA1
RUN
OTQ
Frequency arrival signal
Signal during running
Overtorque signal (Note)
Abbrevia-
tion
Precautions for terminal setting
Same terminals cannot be set between and .
When moving a terminal name to another terminal, set another terminal which is not to be
ued at the setting source before inputting the set value to the setting destination and then
select the terminal name which is to be set at the setting destination.
CM2
12
11
AL2
AL1
AL0
NOTE: The torque of the overtorque signal can be set by the remote operator. The initial
values of motoring and regeneration are 100% torque. The overtorque signal can be
used only under the sensorless vector control.