Filter
Top Products
Chapter 2 • Installing the indoor equipment
1031484-0001 Revision 2
11
Installing the system
using a modem
You need all the items shown in Figure 6. Some of them are in the
modem installation kit or inside the antenna box.
If you are using Web commissioning, you must provide an
Ethernet cable to connect between the DW4020 and installer PC.
If Web commissioning is not available, you must provide a 9-pin
female/female (F/F) null modem serial cable. The serial cable can
be used to configure the DW4020 via the serial port. Appendix C
– Installing the DW4020 Manually, on page 77.
You will also need the installation work order. This is provided to
you by HNS.
Note: At some installation sites, the USB cable that comes with
the DW4020 may not be long enough to reach from the installer
PC to the DW4020. You may need a long USB cable.
Figure 6: Items required for installation
Read this manual and obtain serial cable and installation work order
These items are packaged in a small box inside your antenna box
Installation manual
25-pin connector cable
Receive modem
Transmit modem
USB cable
DC cord
AC cord
Power supply
1031105-0001
Clips
This m
anual
Gateway
9-pin F-F serial cable
Power adapter
Install Spec
Install specification
Ethernet cable