Filter
Top Products
Chapter 2 • Installing the indoor equipment
1031484-0001 Revision 2
25
8. After the customer enters registration information, write the
information in Figure 20 on the cover of their User Guide.
9. Select
Continue in the Registration screen in Figure 20. The
Antenna Pointing - Antenna Location screen appears. See
Figure 21.
10. Verify that the ZIP code shown matches the ZIP code for the
installation site. If not, correct it. Select Next. The
Antenna
Pointing - Receiver
screen appears. See Figure 22. At this
point it shows no signal strength or auto cross-pol checkbox.
11. Click through all pointing screens by selecting Next. Click
through until you reach the
Websetup - Finish screen. You
will finish registration before peaking the signal.
12. When the
Websetup-Finish screen appears, Websetup
receives a parameter file from the WebACS and transfers it to
the DW4020 over the Ethernet connection. If it is successful,
a message appears asking you to press Finish. See Figure 23.
13. Select Finish. The unit is commissioned. A message may
appear telling you to connect and reconnect the USB cable.
Click OK. You do not need to do anything with the USB
cable at this time.
Figure 21: Enter ZIP code
Note: You must not disconnect the power cables before
completing Step 13. Finish registration before peaking the signal.