Juniper Networks G10 CMTS Network Card User Manual


 
Perform Initial Software Configuration
JUNOSg 3.0 G10 CMTS Hardware Guide
130
12. Optionally, configure additional properties by adding the necessary configuration
statements. Then, commit the changes to activate them on the CMTS.
[edit]
root@host-name# commit
13. When you have finished configuring the CMTS, exit configuration mode.
[edit]
root@host-name# exit
root@host-name>
The CMTS is now connected to the network but is not fully configured. You must perform
additional configuration before the CMTS can pass traffic. For complete information about
configuring the CMTS, including examples, see the JUNOSg software configuration guides.