Juniper Networks G10 CMTS Network Card User Manual


 
Tools and Equipment Required for Installation
JUNOSg 3.0 G10 CMTS Hardware Guide
74
Tools and Equipment Required for Installation
You need the following tools to complete the G10 CMTS installation:
! M2.5 Phillips torque screwdriver
! M2.5 flathead torque screwdriver
! M3 Phillips torque screwdriver
! M5 Phillips torque screwdriver
! #10 Phillips torque screwdriver
! #10 flathead torque screwdriver
! #12 Phillips torque screwdriver
! 7/16 in. torque wrench
! 22-10 AWG crimper/cutter/stripper
In addition, you might need the following supplies:
! RF cables and adapters
! Ethernet cables with RJ-45 connectors
You need the following equipment to configure the G10 CMTS and verify that the RF system
has been set up properly:
! PC with asynchronous terminal emulation
! RF spectrum analyzer
! RF power meter