Juniper Networks G10 CMTS Network Card User Manual


 
Replacement Procedures
Module Removal
169
Figure 48: HFC Connector Module Removal
Remove a Chassis Control Module
The Chassis Control Module is hot-swappable. However, if you hot-swap the Chassis Control
Module, all services supported by the CMTS are lost because the CMTS cannot operate
without the Chassis Control Module.
To remove a Chassis Control Module, follow this procedure:
1. Stop the CMTS software by issuing the request system halt command:
user@host> request system halt
2. Power down the CMTS.
3. Follow the same procedure described in “Remove a DOCSIS Module” on page 166.
3
Eth
0
Eth
1
US 3
US 2
U
S
1
U
S
0
D
S
3
DS 2
D
S
1
DS 0
1
1
2
2