Filter
Top Products
10. If you have a hot-swap model, reinstall the hot-swap power supplies (see
“Installing a hot-swap power supply” on page 96).
11. Install the side cover (see “Installing the side cover” on page 79).
12. Lock the side cover.
13. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing a hot-swap hard disk drive
Attention: To maintain proper system cooling, do not operate the server for more
than 10 minutes without either a drive or a filler panel installed in each drive bay.
To remove a hot-swap SAS or hot-swap SATA hard disk drive, complete the
following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 73.
Note: You do not have to turn off the server to remove hot-swap drives from
the hot-swap drive bays.
2. Unlock the side cover.
3. Remove the bezel (see “Removing the bezel” on page 76).
4. Rotate the drive tray handle of the drive assembly to the open position.
1 Hard disk drive
2 Drive tray
3 Drive tray handle (in open position)
5. Grasp the handle of the drive assembly and pull the assembly out of the bay.
6. If you are instructed to return the drive assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 4. Removing and replacing server components 89