Filter
Top Products
Enabling the Serial ATA (SATA) controller: To enable the SATA RAID controller,
complete the following steps:
1. Turn on the server.
2. When the prompt Press F1 for Configuration/Setup appears, press F1. If you
have set an administrator password, you are prompted to type the password.
3. Select Devices and I/O Ports --> Advanced Chipset Control.
4. Select SATA Controller Mode Option. Change the value to Enhanced.
5. Scroll down and select SATA RAID Enable.
6. Select Enabled.
7. Press Esc; then, select Yes to save the changes.
Using the Adaptec RAID Configuration Utility program:
Note: Adaptec RAID (also known as HostRAID) is not supported on the SCO 6.0
and UnixWare 7.14 operating systems.
Use the Adaptec RAID Configuration Utility program to perform the following tasks:
v Configure a redundant array of independent disks (RAID) array
v View or change the RAID configuration and associated devices
For additional information about using the Adaptec RAID Configuration Utility
program, see the documentation on the IBM ServeRAID-8e (Adaptec HostRAID)
Support CD that comes with the server.
Adaptec RAID Configuration Utility menu choices: The following choices are on the
Adaptec RAID Configuration Utility menu:
v Array Configuration Utility
Select this choice to create, manage, or delete arrays, add or delete a hot-spare
drive, or initialize drives.
v SerialSelect Utility
Select this choice to configure the controller interface definitions or to configure
the physical transfer and SATA address of the selected drive.
v Disk Utilities
Select this choice to format a disk or verify the disk media. Select a device from
the list and read the instructions on the screen carefully before making a
selection.
Starting the Adaptec RAID Configuration Utility program: To start the Adaptec
RAID Configuration Utility program, complete the following steps:
1. Turn on the server.
2. When the prompt Press <CTRL><<A> for Adaptec RAID Configuration Utility
appears, press Ctrl+A.
3. To select a choice from the menu, use the arrow keys to highlight it and press
Enter.
Creating a RAID array: To use the Adaptec RAID Configuration Utility program to
configure a RAID level-1 array, complete the following steps:
1. Start the Adaptec RAID Configuration Utility program.
2. Select Array Configuration Utility.
3. Select Create Array.
Chapter 2. Configuration information and instructions 19