Filter
Top Products
Removing the front adapter-retention bracket
To remove the front adapter-retention bracket, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 73.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see “Removing the side cover” on page 78).
4. Open the front and rear adapter-retention brackets.
5. Remove all adapters and place them on a static-protective surface.
Note: You might find it helpful to note where each adapter is installed before
removing the adapters.
6. Grasp one side of the bracket at a hinge point and pull outward (while rotating
the bracket slightly toward the rear of the server) until the hinge pin on the
bracket is free of the hole; then, push the bracket in the opposite direction to
release the other side of the bracket and remove the adapter retention bracket
from the server.
Installing the front adapter-retention bracket
To install the front adapter retention bracket, complete the following steps:
1. Insert one of the hinge pins on the front adapter-retention bracket into the metal
hinge point on the fan cage assembly.
2. Rotate the other hinge pin into position and push the end of the
adapter-retention bracket into the hinge point. The hinge pin will protrude
through the hole in the metal hinge point when the adapter-retention bracket is
seated correctly.
3. Reinstall any adapters that you removed earlier.
4. Close the front and rear adapter retention brackets.
5. Install the side cover (see “Installing the side cover” on page 79).
6. Lock the side cover.
7. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Chapter 4. Removing and replacing server components 113