Filter
Top Products
Statement 2:
CAUTION:
When replacing the lithium battery, use only Lenovo Part Number 33F8354 or
an equivalent type battery recommended by the manufacturer. If your system
has a module containing a lithium battery, replace it only with the same
module type made by the same manufacturer. The battery contains lithium
and can explode if not properly used, handled, or disposed of.
Do not
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
To install the battery, complete the following steps.
1. Follow any special handling and installation instructions that come with the
replacement battery.
2. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
3. Install the side cover (see “Installing the side cover” on page 79).
4. Lock the side cover if it was unlocked during removal.
5. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
6. Start the Configuration/Setup Utility program and reset the configuration.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See “Using the Configuration/Setup Utility program” on page 16 for details.
Removing the RAID 8k-l adapter
To remove the ServeRAID 8k-l adapter, complete the following steps:
1. Read the safety information beginning on page “Safety” on page vii, and
“Installation guidelines” on page 73.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables. Remove the side cover (see “Removing the side cover” on
page 78).
Attention: To avoid breaking the retaining clips or damaging the ServeRAID
8k-l adapter connector, open and close the clips gently.
Chapter 4. Removing and replacing server components 115