McDATA OPENconnectors Command Line Interace Network Card User Manual


 
2
CLI Commands
McDATA OPENconnectors Command Line Interface USER MANUAL P/N 620-000134-300
2-70
2XWSXW([DPSOH The output from the show.frus command displays as follows.
FRU Position State Serial Num Part Num Beacon Pwr On Hrs
----- -------- ------ -------------- --------- --------- ----------
CTP 0 Active 470-000399-700 123456789 Off 2800
CTP 1 Backup 470-000399-700 223456789 On 2801
SBAR 0 Active 470-000399-700 223456789 Off 2801
SBAR 1 Failed 470-000399-700 223456789 Off 2801
FPM 1 Active 470-000399-700 223456789 Off 2801
FPM 3 Active 470-000399-700 223456789 Off 831
UPM 4 Active 470-000399-700 223456789 Off 831
Power 0 Active 470-000399-700 223456789 Off 831
Fan 0 Active 470-000399-700 223456789 Off 831
VKRZLSHWKHUQHW
6\QWD[ ethernet
3XUSRVH This command displays ethernet attributes.
3DUDPHWHUV This command has no parameters.
&RPPDQG([DPSOH Root> show ip ethernet
2XWSXW The Ethernet attributes data is displayed as a table that includes the
following properties.
2XWSXW([DPSOH The output from the show.ip.ethernet command displays as follows.
LAN Information
IP Address: 144.49.10.15
Gateway Address: 144.49.10.1
Subnet Mask: 255.255.255.0
IP Address The IP address for the Ethernet adapter as set in
the config.ip.ethernet command.
Gateway
Address
The gateway address for the Ethernet adapter
as set in the config.ip.ethernet command.
Subnet Mask The subnet mask for the Ethernet adapter as set
in the config.ip.ethernet command.