McDATA OPENconnectors Command Line Interace Network Card User Manual


 
CLI Commands
config
2
2-31
FRQILJVQPSVKRZ
6\QWD[ show
3XUSRVH This command shows the switch SNMP configuration.
3DUDPHWHUV This command has no parameters.
&RPPDQG([DPSOH Root> config snmp show
2XWSXW The switch configuration data is displayed as a table that includes the
following properties.
2XWSXW([DPSOH The output from the config.snmp.show command displays as
follows.
Authorization Traps: Enabled
Index Community Name WriteAuth Trap Recipient UDP Port
----- -------------------------------- --------- --------------- --------
1 CommunityName1 Enabled 123.123.123.123 162
2 CommunityName2 Enabled 10.25.25.10 144
3 CommunityName3 Disabled 132.44.85.224 162
4 public Enabled 162
5
6
Authorization
Traps
The state of the authorization traps (for
example, enabled) that are sent to SNMP
management stations when unauthorized
stations attempt to access SNMP information
from the switch.
Index
The community index number.
Community Name
The name of the community.
WriteAuth
The write authorization state.
Trap Recipient
The address of the trap recipient.
UDP Port
The user datagram protocol (UDP) port number
to which the director will send traps for each
recipient.