Filter
Top Products
DM800™, DM900™ Digital Mailing System Operating Guide
SV60861 Rev. F 4-13
4. Select Differential Weighing. The system prompts you to place the
mail on the scale.
5. Place the mail on the scale.
• If you have previously selected a class, the system displays the fol-
lowing prompt at the top of the screen: Print tape
s automatically
On or Off.
- If you select On, then whe
n you remove each piece of mail, the
system automatically prints a tape.
- If you select Off, you re
move the first piece of mail and place it
on the feed deck. The system automatically feeds the mail.
• If you have not previously selected a class, you a
re prompted to
select one now. For more information, refer to “Selecting the Class,
Carrier, Special Services or Options” in this chapter.
6. Begin removing mail from the scale. Please no
te the following:
• Remove each piece of mail in a single continuous motion.
• If you mistakenly remove more than one piece of mail, put all of the
pieces of mail back on the
scale. If you only put one piece back on,
the system does not print the correct postage.
7. When you remove the last piece of mail fro
m the scale, the system asks
you if you want to print postage. This is in case the last piece you
remove from the scale is the container for the mail.
8. If you are using the optional Power St
acker, we recommend you
remove your mail in manageable stacks and not allow the deck to fill
completely. The system will halt the stacker if it is filled to its maximum
capacity.
Mode Selection:
Manual Weight
Entry
To perform manual weight entry:
1. Press the Mode key
.
2. Select Manual W
eight Entry.
3. Type in the number of pounds and press Enter.
4. If the weight of your mail is less than 1 lb, press the right arrow key to
go to the ounces
field.
5. Type in the number of ounces and press Enter.
Press the Class key if required a
nd select the class. For more informa-
tion, refer to “Selecting the Class, Carrier, Spec
ial Services or Options”
in this chapter.
6. If this is a package, press the Tape key
, otherwise go to step 7.
7. Place the piece of mail on the feed deck.
8. Press the Sta
rt key.
9. If you are using the optional Power St
acker, we recommend you
remove your mail in manageable stacks and not allow the deck to fill
completely. The system will halt the stacker if it is filled to its maximum
capacity.
CAUTION: Make sure you center the mail on the scale and
check to be sure it is not touching any other surface or object.
NOTE: If the weight you enter is invalid for the class, you are prompted to
select another class.