Filter
Top Products
Administrator’s Guide for ViewStation EX, ViewStation FX, and VS4000
2-20 www.polycom.com/videodocumentation
To connect an additional PTZ camera other than PowerCam:
For more information about how to connect an additional camera, refer to the
setup sheet that came with your system.
To a ViewStation FX system: To a VS4000 system:
1. Connect the 7-pin connector end of the
Y-shaped PTZ cable to the camera 4
port on the rear panel of the system.
2. Connect the 4-pin end of the Y-shaped
PTZ cable to the S-video connector on
the camera.
3. Connect the 8-pin end of the Y-shaped
PTZ cable to the 8-pin VISCA IN port on
the camera.
4. Connect the camera’s power pack or
cord to a power outlet.
1. Original VS4000: Connect an S-video
cable to the camera’s S-video connector
and to the system’s Camera 4 S-video
connector.
Enhanced VS4000: Connect an
S-video cable to the camera’s S-video
connector and to an S-video to BNC
adapter.
Connect the adapter’s yellow BNC
connector to the camera 4 C connector,
and the white connector to the camera 4
Y connector on the VS4000 system’s
rear panel.
2. Connect a mini-DIN to DB-9 VISCA
cable from the camera’s VISCA IN
connector to the system’s Camera 4
control connector.
3. Be sure the camera’s power switch (if
any) is off.
4. Connect the camera’s power pack or
power cord.
5. Connect the power cord to a power
outlet.
2
3.3V
12V 3A
7A
2
4
XVGA
1
3
4
Camera 4
2
4
1
4321
3
5
XVGA
4
0101
1
Y
C
Y
C
Camera 4 Control
Camera 4 Y
Camera 4 C