Filter
Top Products
145
PRIMERGY RX300 S2 User’s Guide
5
Operations after OS Installation
5.4 Creating Maintenance Tools
This section explains how to create tools for maintaining the server.
Maintenance tools are created with the FloppyBuilder function of ServerStart.
With the FloppyBuilder function of ServerStart, you can create the following tools.
• DOS floppy disks
• Hardware Configuration Tools (such as Server Management Tools)
The FloppyBuilder can be used under environments such as.
• the ServerStart system started on a client computer (recommended)
• the system started on the server using the ServerStart CD-ROM
When creating the tools on a client computer, install ServerStart on the computer beforehand. Install
ServerStart according to "2.4 Preparation for Using ServerStart on a Client Computer" (pg.52).
If ServerStart of a different version is installed in the computer, make sure to uninstall the ServerStart.
Then perform installation again. For details on how to uninstall ServerStart, refer to "2.4.2 Uninstalling
ServerStart" (pg.54).
The FloppyBuilder function may not operate correctly if you start up ServerStart while ServerStart of a
different version is installed in the computer. Make sure to uninstall a different version of ServerStart.
5.4.1 Creating a DOS Floppy Disk
For DOS data stored into the floppy disk, refer to the file in the following folder of the ServerStart CD-
ROM.
[CD-ROM drive]: \FreeDOS
To create a DOS floppy disk, you need an unused floppy disk. Prepare it in advance.
If ServerStart has already been started, it is not necessary to restart it. If it has not, start it up according to
the following procedures.