Filter
Top Products
22
Chapter1 Overview
1.3 Component Names and Functions
This section explains the component names and functions of the server.
1.3.1 Server (Front View)
a 3.5-inch storage bay
Install the internal hard disk unit or internal backup device into the server unit.
b Floppy disk drive
Writes/reads data to/from a floppy disk.
c System identification LED button
When pressing this button, the front and rear system identification LEDs are lit blue so that the
locations of devices being maintained can be determined.
d Power LED ( )
This LED is lit green when the server is turned on. This is lit amber when the server is not turned
on (standby mode). This does not light when the power cable is unplugged from the outlet.
e Hard disk access LED ( )
This LED blinks when data is being written to or read from the hard disk.
f Failure LED ( )
This LED lights or blinks in amber when an error is detected in the server components. If this
LED lights, contact an office listed in the "Contact Information" of the "Start Guide".
g Power switch ( )
Press this switch to turn the server on.
Do not turn the server off when the hard disk access LED is blinking.
Data in the hard disk may be damaged.
h Reset switch ( )
Pressing this switch resets and restarts the system.
dgfehc
b
k
j
ia
a
l
R
S
T