Filter
Top Products
33
PRIMERGY RX300 S2 User’s Guide
1
Overview
1.4.3 Turning Off the Server
1 Make sure that the floppy disk drive and CD-ROM drives are empty.
2 Shut down the OS.
In the following cases, the server is turned off after the OS is shut down (Step 3 is not necessary).
• Windows OS
• When ServerView is installed
In other cases, shut down the OS and make sure that the floppy disk and hard disk access LEDs
are off.
3 Press the power switch on the front of the server.
The server's power LED lights amber, and the server is turned off.
4 Turn off the display and peripheral devices.
The time to turn on/off the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView supplied with this server.
For details, refer to "3.2 Settings for Server Monitoring" in "ServerView User's Guide" on the
PRIMERGY Document & Tool CD (Disk 2).
• In the event of smoke or sparks, immediately unplug the electric cord. Failure
to do so may lead to a fire or electrocution.
• When turning off the server, be sure to follow the procedures described in this
section. Data can be lost if these procedures are not followed correctly.
• Be sure to wait for 10 seconds or longer after shutdown before turning the
server on.
The servers power
LED is lit amber
Power switch