Filter
Top Products
173
PRIMERGY RX300 S2 User’s Guide
Installing Internal Options
7
When installing or removing devices, make sure to use the removed screws on the same location and
devices that were last installed or removed. Failure to do so may damage the device.
The types of installable options described in this manual are subject to change without notice.
• When installing/removing internal options to/from the server, turn off the server,
all peripheral devices, and any other connected devices. Also unplug all power
cables from the server. Failure to do so may cause electric shock ("1.4.3
Turning Off the Server" (pg.33)).
When configuring an array system (RAID1/5/10), the internal hard disk units
can be replaced without turning the power off.
• Do not disassemble the PSU. Doing so may cause electric shock.
• Do not install unauthorized third party internal options.
Doing so may cause a device failure, fire, or electric shock.
• Do not damage or modify internal cables or devices.
Doing so may cause a device failure, fire, or electric shock.
• Devices inside the server remain hot after shutdown. Wait for a while after
shutdown before installing or removing internal options.
• The circuit boards and soldered parts of internal options are exposed. They
can be damaged by static electricity.
Before handling them, first touch a metal part of the server to discharge static
electricity.
• Do not touch the circuitry on boards or soldered parts. Hold the metallic areas
or the edge of the circuit boards.
• If devices are installed using the methods other than those outlined in this
chapter or disassembled, the warranty will be invalidated.