Filter
Top Products
235
PRIMERGY RX300 S2 User’s Guide
8
Hardware Configuration/Utilities
8.2.8 Advanced System Configuration Submenu
Appears when [Advanced System Configuration] is selected from the [Advanced] menu.
Configures additional settings.
table: Items on the Advanced System Configuration Submenu
Item Setting Description
PCI Bus Parity Checking Enabled (Fixed parameter) Sets whether to enable or disable the PCI bus parity
checking.
Memory Redundancy
• Disabled (at the time of
purchase)
• Sparing
• Mirroring
Sets whether or not to use the spare memory or
mirror function.
To use the spare memory or mirror function, install
ServerView.
Remap PCI Memory Gap • Disabled (at the time of
purchase)
• Enabled
Specify an area to be allocated to PCI Memory Gap.
Note:
When installing 4GB or more memory, set to
[Enabled].
CPU Mismatch Detection Enabled (Fixed parameter) Sets whether to enable or disable checking the CPU
type and frequency.
CPU Timeout Counter Disabled (Fixed parameter)
The server does not support this.
CPU Frequency (GHz)
Automatic (Fixed
parameter)
Configures the CPU clock frequency.
Hyper-Threading
• Disabled
• Enabled (at the time of
purchase)
Sets whether or not to run one CPU as a dual-
processing CPU. The setting [Enabled] may
enhance processing performance by allowing
maximum use of the CPU resources.
Limit CPUID Functions
Disabled (Fixed parameter) Configures the CPU internal setting.
CPU Thermal Management
Enhanced (Fixed
parameter)
Configures the CPU internal setting.
Note:
This item is displayed only when using the
3.6GHz CPU.
Item Specific Help
Select Item
Select Menu
Change Values
Select Sub-Menu
-/+
Enter
F1
Info
Esc Exit
F9
Setup Defaults
F7
Previous Values
PhoenixBIOS Setup Utility
Advanced
PCI Bus Parity Checking: [Enabled]
Memory Redundancy: [Disabled]
Remap PCI Memory Gap: [Disabled]
USB Host Controller: [Enabled]
USB2.0 Host Controller: [Enabled]
USB BIOS Legacy Support: [Disabled]
Advanced System Configuration
CPU Mismatch Detection: [Enabled]
CPU Timeout Counter: [Disabled]
CPU Frequency(GHZ): [Automatic]
Hyper-Threading: [Enabled]
Limit CPUID Functions: [Disabled]
CPU Halt Mode(C1E): [Standard]
CPU Thermal Management: [Enhanced]
NX Memory Protection: [Disabled]
CPU MC Status Clear: [Next Boot]
Enhanced SpeedStep: [Disabled]
CPU Throtting Delay: [No Delay]