Filter
Top Products
266
Chapter 9 Operation and Maintenance
■ Error Messages during Installation
The following error messages may appear during installation using ServerStart. Check the corrective
action against the relevant error.
● "WzDiskAdmin: System Error! ......................, Last Error: The device is not
ready." appears.
Optional SCSI devices (e.g., hard disk cabinet, MO disk unit, or DAT unit) may be connected.
Disconnect the optional SCSI devices and perform installation again. Connect the optional devices after
the installation completes.
● "WzDiskAdmin: Partition detected! Please delete all partition before starting
Configuration" appears.
Run the guide or preconfiguration mode again. Check [Delete all partitions on the displayed disk] in the
disk wizard.
● "WzRaid: RAID arrays detected! Please delete all RAID arrays before starting
Configuration" appears.
Use the ServerStart floppy disk you have created. Check [Delete existing RAID array] or select [Use
existing array] in the RAID wizard.
● "Operating System not found" appears when the system restarts after file
copy from the CD-ROM.
The following are possible causes. Check them.
• The array controller card comes later than the onboard SCSI array controller in order of device
startup.
• The Active flag is specified.
• The BIOS setting of the RAID card connected to the internal hard disk unit is set to [Disable]. For
details on the BIOS setting of the RAID card, refer to the user guide supplied with the RAID card.
● "Missing Operating System" appears during installation.
The installation partition size may be too large. Specify the installation partition size correctly.
For details on the installation partition size, refer to "2.3.1 Installation Partition Size" (
pg.47).
● "Error 1920. Service (PXE Services) failed to start" appears during
preconfigured installation.
The system installed with the preconfigured settings (PXE server) may not be connected to the network.
Check the LAN cable connection and click [Rerun].
■ Error Window Appears after LAN Driver Installation (on Windows
Server 2003)
The following window may appear when the installation of the LAN driver to the [Ethernet controller]
under [Other devices] starts.